Electrical Installations: Learn How To Avoid The Most Common Problems
Electrical installations are quite complex and require technical and theoretical knowledge and total attention to be carried out. It is not difficult to find cases of people who quickly finish a renovation or work to save on expenses and, later, have problems with the installation, for example, which was not done in the best way.
The fact of not paying attention to the necessary precautions can leave your installation vulnerable to several errors, causing the cost increase and compromising the property’s safety and the project’s good finish. Still, failures can have dire consequences, such as overloading electrical components, leading to shocks, short circuits, and even fires.
To avoid failures in your electrical installation, High Voltage Electric have selected the most common problems, explaining why they harm your home and what you can do to avoid them! Keep watching and check it out. Good reading!
Installation Overhead
Here we have a precaution that you should take every day. Overloading benjamins, rulers, and sockets are undoubtedly one of the most common mistakes in electrical installations. Connecting several electronics at the same point increases the chance of damaging the equipment, having a short circuit, or even an accident, such as electric shocks.
Overload can also happen in the electrical circuit. Good examples are electric faucets, air conditioning, and showers, among other appliances with greater power, which need to be installed in separate circuits. Therefore, never use the same breaker for different circuits.
Taken Near The Water
It is a fact that you will need outlets in the kitchen, laundry room, and bathroom. But it is necessary to pay extra attention in these environments. To do so, try to install the sockets at a certain distance from the water sources, as it conducts electricity, so keeping the sockets out of that reach will reduce the chances of damaging the equipment and electric shocks. Also, avoid manipulating appliances when your hands are wet.
Failure To Install The DR (Residual Differential)
The DR (Residual Differential) device is a mandatory component related to the safety of residents. It protects against electric shocks, being decisive in places that can get wet, such as service areas, kitchens, bathrooms, saunas, swimming pools, etc. Residual differentials need to have high sensitivity.
Flashing Lights
When the lights are flashing, there is a bad electrical connection. You can trace the source of the connection by noting which lights are like this. If all are, you will have to review the panel. Fixing this problem is a job for an electrician. If the flickering is located in only one room, it is usually a loose or bad switch connection. In addition, it is essential to check all sockets, as some may be connected to the light circuit.
Shower Change
Changing the shower may seem commonplace and very simple, but you need to be careful, as one of the most common mistakes is installing a shower with power above what the installation supports. Therefore, you need to check the shower’s power carefully and whether it is equivalent to your current installation. If you are unsure about doing this job, it is best to seek professional help such as Electrical Services from Master Electrician in South Florida for example. Doing this can prevent an accident or the shower from burning due to an incorrectly installed device.
Looking for reliable Perry Electrician Services? Look no further than Perry Power Solutions. Our team of skilled electricians is dedicated to providing high-quality electrical services, including installation, repair, and maintenance.
